Aulick Industries

Belt Trailer Rentals

Belt Trailer

Purchase or Rent

Trailer Inventory

Auluminator

Portable Hydraulic Wet Kit

Per Month

$300.00 Per Month Installed on an Aulick Rental Trailer

$500.00 Per Month Wet Kit ONLY Rental

Additional Options Available

Per Month

$300.00 Per Month Triple Axle Trailer

$600.00 Per Month Quad Axle Trailer

If you would like to purchase from our Rental Fleet after renting:

Purchase within 30 days allows 100% of paid rent credit back toward the purchase of rented Trailer or Dump Cart.

Rent with option to buy is available with 50% paid rent and damage deposit back toward the purchase of rented trailer or dump cart.

Aultimate Belt Trailer

Features and ‘Specs’

  • 54″ Belt
  • Bolt-on 5th wheel
  • Eskridge Gear Drive #9, 130,000 inch-lb torque, 18,000 pound radial load
  • 2-15/16″ diameter rear driveshaft, with weld-on sprockets and splined hub
  • The top hinge hydraulic main gate is 41″ above the top of the trailer when open
  • A plastic floor liner is UHMW 3/8″ thick, full width
  • Plastic Sideliner is one piece of HMW 3/16″ thick, trailer is fully lined
  • Extended rear discharge with wings on the rear of the trailer
  • Hydraulic pressure line filter with replaceable element
    Mechanical latch on the rear gate (operates with knife gate)
  • The hydraulic control valve, flow control, and pressure gauge are mounted at the left rear
  • Main Frame Rails are one-piece, full-length steel 10″ I-beam
  • Sides of the trailer only have one seam
  • Optional Side-sheeting
  • Front and Rear Fenders
  • 50,000 lb landing gear
  • Haldex ABS – 2S/1M anti-lock brake system
  • 11×22.5 radials on 10 bolt hub pilot rims
  • Hendrickson Intraax air ride suspension with Haldex quick-acting leveling valve
  • Various axle combinations available
  • Shur-loc roll tarp
  • DOT lighting and reflective tape
  • Other options available

Aultimate Belt Trailer

Features & ‘Specs’

  • 66”, 72” & 84” Side Heights
  • 54” Wide Belt
  • High Torque Gearbox
  • 2 15/16” Rear Drive Shaft
  • Patented Sprockets
  • Front Take-up Frame with HD Roller Bearings
  • Hydraulic Top Hinged Main Gate & Knife Gate
  • 1/4” UHMW Plastic Floor Liner
  • 3/16” HMW Full Height Side Wall Liner
  • .125 Aluminum Floor Pans
  • .090 Aluminum Side Slopes
  • Hendrickson Intraax Air Ride Suspension
  • 11Rx 22.5 Hub-Piloted Aluminum Wheels
  • Sloped Sides for Great Clean-out.
  • Extended Rear Discharge with Wings.
  • 1/4” Floor Liner
  • Fully Lined with HMW plastic
  • Main Frame and Suspension Sub-Frame are Steel.
  • Cross Stringers on 15” Centers.
  • State of the Art Hydraulic Components
  • Wall Posts 22” center
  • Slope Supports 24”
  • Aluminum Knife Gate
  • Wheels Back Axle placement eliminates the tow hook bar and rear bumper
  • Allows for a greater bridge.
  • Bolted in Z-Supports eliminates cracks.
  • Optional – 25 HP Power Unit